装载机液压系统的防漏措施-凯发k8官网下载

一是减少装载机冲击和振动，使用减振支架固定所有管子，适当布置压力控制阀以保护系统的所有元件，尽量减少管接头的使用数量并尽量采用焊接，使用直螺纹接头、三通接头和弯头代替锥管螺纹接头。
one is to reduce the impact and vibration of shandong loader, using damping bracket fixed all the pipes of all components appropriately arranged pressure control valve to protect the system, try to reduce the number of joint use and adopt welding, using straight thread joints, three joints and elbow instead of tapered pipe thread.

二是减少装载机动密封件的磨损，消除活塞杆和驱动轴密封件上的侧载荷；用防风圈、防护罩和橡胶套保护活塞杆，防止磨料、粉尘等杂质侵入。
the two is to reduce the loading of the shandong motor seal wear, eliminate the piston rod and drive shaft seal on the side load; with the wind ring, protective cover and rubber sleeve to protect the piston rod, prevent abrasive, dust and other impurities intrusion.

三是控制装载机油温，防止密封件变质，温度每升高10℃，密封件使用寿命就会减半。应该根据设备的实际使用情况设置冷却装置，使油液温度保持在65℃以下。使用的油液与密封材料要相适应，以延长密封件的使用寿命。
the three is to control the shandong loader oil seal, to prevent deterioration, increasing the temperature of 10 deg c, the service life of the sealing element will be halved. the cooling device should be set according to the actual use of the equipment to keep the oil temperature below 65 degrees celsius. the use of oil and sealing materials to adapt to extend the service life of seals.